Home Page › Forums › Modeling the Missouri Pacific, Texas & Pacific, etc › HO Scale › Modeling a MoPac E-7 › Reply To: Modeling a MoPac E-7
May 6, 2019 at 11:52 pm
#9362
lenaculbert50
Participant
Some cutting, trimming and filing later, I have the openings ready to fit the printed parts.
I was able to go to the upright rivet strip at the front. The same at the rear. The only thing I hesitated on was at the center hood door. The door has a frame that slides into dovetailed slots on the interior. I had hoped to keep the slots intact, but am worried about a clean gap on the parts.
Anyway, this is my prototype so will see how it goes. Once I get the parts fitted, I’ll be back.
