Home Page › Forums › Modeling the Missouri Pacific, Texas & Pacific, etc › HO Scale › Modeling a MoPac E-7 › Reply To: Modeling a MoPac E-7
May 10, 2019 at 9:26 pm
#9367
lenaculbert50
Participant
Latest progress:
The replacement panels were printed a little oversize so I could match the fit to the openings. I think they would have looked better if I had cut the opening all the way to the center door frame. It would cause the doors to be fixed, but I don’t expect them to be opened anyway.
The resin is a little softer than the plastic. Because of this, it sands easier and you can cut into it quicker when trying to fill the gap.
It also seems the details are a little too tall. I don’t think it will be noticed much in paint but I’m going to adjust the drawing.
