Home Page › Forums › Modeling the Missouri Pacific, Texas & Pacific, etc › HO Scale › Help with Mopac Spark Arresters details › Reply To: Help with Mopac Spark Arresters details
Somewhere I have slides I took of brand new arresters sitting on pallets outside the Ewing Ave diesel shop in St Louis, mid-70s. I’m pretty sure there were two separate sections of screen. I do not recall the screen bending over the top of the bar on top. Need to dig out my slides to verify, if I could remember where I put them oh so many years ago…
@cduckworth wrote:
I ordered a set of Shapeways MP spark arresters and am ready to add them to the Atlas MP15DC.
I’ve cut some fine brass wire mesh to drop into the openings on each side but was wondering if the wire was one piece that covered both sides or there were two seperate pieces – one for each side. I’m thinking it was two seperate pieces on the prototype.
