Reply To: Building a MP GP-12 (1078) Phase III

Home Page › Forums › Modeling the Missouri Pacific, Texas & Pacific, etc › HO Scale › Building a MP GP-12 (1078) Phase III › Reply To: Building a MP GP-12 (1078) Phase III

December 2, 2018 at 4:19 pm #9185
mahcr450
Participant

Posting a picture of the latest prints. This has the exhaust with the brackets, a number board and the radiator fan box with rounded rivets.

I found some 36″ fans in my spares box and they actually fit. If these work, I’m sure the Cannon & Co. fans Charlie recommends will fit too.

The last piece I want to try are the marker lights attached to the number boards.

Charlie – let me know if you see any other adjustments needed. Still haven’t gotten my own RS-3 to check the fit.

If anyone is interested, I could start a separate thread on how I did these. I’m using an Anycubic Photon resin printer. Much better resolution than a filament 3D printer.

Mike